Wedding band and engagement ring: getting the fit right
Many people wear a wedding band next to an engagement ring. If the two are designed separately, the band may not sit flush, and a gap or a tilt appears. Thinking about the pair early avoids this.
What can go wrong
- A gap between the rings, because the setting is wider than the band
- The rings pushing each other, so the engagement ring tilts
- The band catching on prongs or a large gallery
Ways to fit them
- Contour band: a curved band that follows the shape of the setting.
- Notch band: a band with a small cut-out for the setting to sit in.
- Low-set stone: a setting that sits closer to the finger leaves more room.
What to share with the designer
Tell your designer if the ring will be paired with a band. If you already have the band, send its width and thickness, or the file. A matching band can then be modelled from the same setting. See how to design an engagement ring.
Check in a render
Render the two rings together from the side and the front to confirm the fit before casting.
Frequently asked questions
Do I need to buy the band at the same time?
No, but designing it with the ring in mind makes the fit better. A contour band can be made later from the same file.
Can a band be made for an existing ring?
Yes. A designer can model one around the existing setting if you share its measurements or photos.
Related service
Have a design in mind?
Send a sketch, a photo or an idea on WhatsApp and we will tell you what it involves.
WhatsApp us